Summary of Contents for Valon UPS6V-2
- Page 1 Valon UPS6V-2 Battery Supply and Charger Operations Manual Version 1.1 13 May 2016 UPS6V-2 www.valontechnology.com 5/13/2016...
-
Page 2: Table Of Contents
Contents Introduction ............................. 3 Overview ............................3 Detailed Description ........................3 Electrical Specifications ........................... 4 Safety ............................... 5 Battery Care ............................. 5 RoHS (Restriction of the use of certain Hazardous Substances) ............. 5 FCC Part 15 ............................5 Power Connections ..........................5 Input Power Connection ........................ -
Page 3: Introduction
The enclosure is a rugged CNC machined aluminum enclosure with an anti-corrosion finish. The 2000mAh battery is user replaceable and provides up to two hours of use for a Valon 5009 Dual Frequency Synthesizer module with both sources enabled. Much longer battery life can be had with using only one source and even longer with one source and a Valon 5008 Dual Frequency Synthesizer module. -
Page 4: Electrical Specifications
The boost converter maintains a 6.0V output from the 3V lithium battery. The boost converter operates at 2.4MHz and provides a well filtered output with minimal switching noise. The boost converter can provide up to 1.25A to the load and is short circuit protected. The load bypass switch is power MOSFET that sends the 6V input current directly to the output when the 6V input is present. -
Page 5: Safety
20" pig-tail cable assembly. The optimum input voltage for full performance with a synthesizer or similar Valon load is 6.0 Volts minimum. Make sure the power adapter or power supply can deliver the required current both for the load and the charger. For example, if the load is a 5009 requiring typically 540mA and the battery is being charged, then the power supply or ac adapter must be able to deliver ~1.6Amps. -
Page 6: Output Power Connection
There is nothing to prevent connecting the power supply or ac adapter/charger into the 6V OUT connector of the UPS6V-2. Doing so will not damage the power supply or the UPS6V-2. Simply disconnect and reconnect the cable to the correct connectors. -
Page 7: Getting Started Setup
2.1mm x 5.5mm barrel power plug adapter is available from Valon for connecting ac adapters to the pig- tail end of the Hirose power cable. Plug this cable into the UPS6V-2 and apply power from the power supply or ac adapter. -
Page 8: Connectors, Leds, And Switch
6 Connectors, LEDs, and Switch Figure 3 Connectors, LEDs, and push-button switch Charger input: Apply 6V dc to charge the battery and/or provide output power Green LED: Indicates proper input voltage is applied for charging. Note charging voltage can be lower than the required voltage for the certain 6V products. -
Page 9: Mechanical Dimensions
7 Mechanical Dimensions 3.625"W x 2.685"L x 0.55"H Weight: 0.2lbs, 91g Material: AL-6061-T6 Finish: Clear Alodine (conductive) www.valontechnology.com 5/13/2016...