Step 3: Setting Up The Wireless System - Sony 4-147-228-12(1) Operating Instructions Manual

Step 3: Setting up the
Wireless System
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transceivers are inserted
into the unit and the surround amplifier correctly
(page 28).
This wireless system is called "S-AIR." For
details of the S-AIR function, see "Using an
S-AIR Product" (page 61).
COMPONENT VIDEO OUT VIDEO OUT
Y P / C P / C
B B R R
HDMI OUT
LAN(100)
SPEAKER
SPEAKER
CENTER SUBWOOFER FRONT R FRONT L
1 2
4 5
7 8
0
POWER / ON LINE
Indicator
POWER
POWER
POWER/ON LINE
PHONES
PHONES jack
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following Steps.
1
Set the S-AIR ID switch of the unit to A.
2
Press "/1.
The system turns on.
32
US
ANTENNA
EZW-RT10 COAXIAL 75
FM
AM
SAT/CABLE TV EXT TV AUDIO
DC5V 500mA MAX
DIGITAL IN DIGITAL IN
L L
DMPORT
A. CAL MIC
DC5V S-AIR ID ECM-AC2
700mA MAX
A B C
R R
AUDIO IN AUDIO IN
COAXIAL OPTICAL
S-AIR ID switch
"/1
3
6
9
S-AIR ID switch
EZW-RT 10
S-AIR ID SPEAKER
A
B
C
L
PAIRING
SURROUND SELECTOR
R
SURROUND
SURROUND
BACK
SURROUND
SELECTOR switch
3
Set the SURROUND SELECTOR switch
of the surround amplifier to
SURROUND.
4
Set the S-AIR ID switch of the surround
amplifier to A.
5
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If it doesn't, check the transmission
status as follows.
To check the transmission status
You can check the status of sound transmission
between the unit and surround amplifier by
observing the POWER / ON LINE indicator of
the surround amplifier.
POWER / ON LINE Status
indicator
Turns green. Sound transmission is
established.
Flashes green. Sound transmission is not
established.
Turns red. The surround amplifier does
not output sound.
Turns off. The surround amplifier turns
off or its protection is active.
For details of the surround amplifier, see
"Surround amplifier operation" (page 99).
To enjoy sound by using
headphones
You can enjoy the system's sound by connecting
the headphones to the PHONES jack on the
surround amplifier.
Note
• The volume of the unit may become minimum if you
turn off the surround amplifier while the headphones
are connected to the surround amplifier, or radio
reception is poor. In this case, "HP NO LINK" and
"VOLUME MIN" appear alternately in the front
panel display. Check radio reception, and set the
volume again.
• When you connect the headphones to the surround
amplifier, sound is not output from the system's
speakers.