Download Print this page

Installation Instructions - Price DFE Series Manual

Exposed displacement diffuser

Advertisement

EXPOSED DISPLACEMENT DIFFUSER

INSTALLATION INSTRUCTIONS

1
DFE W/DUCT COVER
1.
Remove trim cover (Item 4) by putting finger in opening
(Detail C) at top or bottom and pulling slowly to prevent
bending of trim piece. Keep close for use in final step of
WALL BY
OTHERS
installation.
2A. Mounting angles are shipped attached to the diffuser.
Remove two screws holding the mounting angle to corner
12"
ANGLE MOUNTING
extrusion (Section E-E).
= NOM WIDTH -1.5"
2B. Locate and install 1" x 1" x .100" mounting angles to the
wall in desired location. The mounting angles shall be
installed perpendicular to the floor as per Figure 1 and
spaced apart as per dimension given in Table 2. Failure to
position angles upright and perpendicular to the floor will
result in poor installation. Fasteners supplied by others.
Detail A
FIGURE 1
WALL BY
OTHERS
TOP
12"
= NOM WIDTH -1.5"
WITH DUCT COVER
FIGURES 3 & 4
Detail A
2
FRONT
1
EXPOSED DISPLACEMENT DIFFUSERS - Manual | priceindustries.com
MOUNTING ANGLE
1
FLOOR
A
MOUNTING ANGLE
1
1
Detail B
B
FLOOR
ANGLE MOUNTING
A
SIDE
Detail B
B
TOP
3.
Install diffuser (Item 2) over the mounting angles so that
the back of the diffuser is flush with the wall (see Figure
3,4 & 5). Fasten to mounted angles with screws (Item 5).
Use minimum 2 screws per side of diffuser.
4.
Attach duct to diffuser inlet.
5.
Install next section of mounting angle for the duct cover in
line with diffuser mounting angles. If this is the last section
of duct cover cut the extrusion to fit 1" below the ceiling
height or the height of the duct cover.
6.
Tap trim cover into place with rubber mallet or neoprene
WALL BY
hammer. Care should be taken not to mark/damage trim
OTHERS
cover, diffuser or surrounding wall.
7.
Detailed installation instructions are also available on video
at priceindustries.com.
12"
WALL BY
OTHERS
FIGURE 2
12"
Detail A
Detail A
5
FIGURE 5
WITH DUCT COVER
WITH DUCT COVER
2
5
2
MOUNTING ANGLE
1
1
MOUNTING ANGLE
1
1
FLOOR
ANGLE MOUNTING
= NOM WIDTH -1.5"
FLOOR
ANGLE MOUNTING
= NOM WIDTH -1.5"
A
A
Detail B
B
TOP
Detail B
B
TOP
FRONT
5
5
SIDE

Advertisement

loading