EXPOSED DISPLACEMENT DIFFUSER MOUNTING ANGLE INSTALLATION INSTRUCTIONS DFE W/DUCT COVER Remove trim cover (Item 4) by putting finger in opening Install diffuser (Item 2) over the mounting angles so that (Detail C) at top or bottom and pulling slowly to prevent the back of the diffuser is flush with the wall (see Figure bending of trim piece.
Page 3
EXPOSED DISPLACEMENT DIFFUSER INSTALLATION INSTRUCTIONS Table 1 FIGURE 6 Item # Description Note CUT AS REQ CUT AS REQ Attached to diffuser for Mounting Angle x 2 shipping DFE Diffuser x 1 1 unit up to 60"/multiple DFE Duct Cover units over 60"...
Page 4
EXPOSED DISPLACEMENT DIFFUSER INSTALLATION INSTRUCTIONS DFE NO DUCT COVER Remove trim cover (Item 4) by putting finger in opening Attach duct to diffuser inlet. (Section E-E) at bottom and pulling slowly to prevent Install diffuser (Item 2) over the mounting angle so that bending of trim piece.
Page 5
EXPOSED DISPLACEMENT DIFFUSER BASE COVER INSTALLATION INSTRUCTIONS FOR TOP AND REAR DUCTED UNITS FIGURE 1 Base cover is shipped attached to the bottom of the unit (Figure 1) priceindustries.com | EXPOSED DISPLACEMENT DIFFUSERS - Manual...