Advantech PCM-29R1TX Startup Manual

PCM-29R1TX 1-Port iLink(TX), Long Distant Display
Transmitter, RJ45
Startup Manual
Packing List
Before installation, please make sure that you have:
• 1 x mPCIe module
• 1 x One Ethernet port I/O plate
• 1 x Wired signal & power cable
• 1 x Startup Manual
• 1 x Warranty Card
If anything is missing or damaged, contact your distributor
or sales representative immediately.
Installation
PCM-29R1TX supports Embedded Automation PC UNO
series. Please contact Advantech for detail models.
Some PC may need to modify BIOS setting before installing
PCM-29R1TX as below:
• Chipset->System Agent(SA) Configuration->Graphics
Configuration->Primary Display[IGFX]
• Chipset->North Bridge->Intel IGD Configuration->Primary
IGFX Boot Display[CRT]
• Chipset->North Bridge->Intel IGD Configuration-
>Secondary IGFX Boot Display[EFP]
Documentation/Software Support Guide
The Startup Manual is included in the package. The other
support documentation such as datasheet and drivers can
be accessed from Advantech's website.
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
For technical support and service, please visit our
support website at:
http://support.advantech.com
This manual is for the PCM-29R1TX.
Part No. 200329R100
Print in China
UNO Embedded Computer Installation
1. Remove the screws from the base plate and lift to
2. Insert the mini-PCIe card and secure the screws.
3. Remove the screws to remove the blank expansion
1st Edition,
April 2017
remove.
plate.
PCM-29R1TX Startup Manual 1