NADAMOO Bur3074 Quick Start Manual

Bur3074 NADAMOO 2.4G Wireless & USB wired Barcode Scanner
In order to correctly use the bar code scanner, please read the instruction
carefully and do not arbitrarily scan the settings code, otherwise some
settings may not be available.
Please keep this instruction for reference in the future.
If you have any question or concern about the operation of the scanner,
please contact us at Email: server@nadamoo.cn / burnfree@126.com.
Package Include:
1 x Bar code scanner
1 x USB cable
1 x USB Wireless receiver
1 x User manual
Charging
Please ensure that the scanner has enough power. If the scanner runs out of
power, the buzzer will ring for seconds, and the scanner will shut down
automatically. At this case, please stop scanning and recharge the scanner.
Please insert one end of USB cable into the scanner correctly, and insert
another end to computer USB interface or 5V DC USB interface power (NOTE:
please use computer USB interface or special 5V DC power supply to charge, the
abnormal power will cause permanent damage to scanning gun and battery).
Yellow LED light will light up when the scanner is at charge statue. It will take
about 4 hours to recharge the scanner. After full charged, the LED light will go
out automatically.
Connection Setting
This scanner has two connection mode:
Mode 1: Wired Mode.
Set by steps ：
1. Connect the scanner to your computer via USB cable;
2. Scan the code " PS2 keyboard wired mode " to convert the scanner to wired mode.

Quick Start Guide

PS2 keyboard wired mode
1