Summary of Contents for LabTeam Innovations SureKey
Page 1
SureKey A Unique Solution To Everyday Problems User manual Read this instruction before you get started to avoid damages and to make SureKey more effective. LabTeam Innovations LTD takes no liability for any damages caused by not following this instruction, which may also void the warranty.
5. Modifications can be done only by the manufacturer. 6. Manufacturer is not responsible for bodily injury or damage to equipment due to improper handling. Kit contents 1. SureKey 2. Battery CR2016 3. Epoxy glue with a mixing end 4. Rubber band 5.
Home position SureKey helps find the key if it doesn’t get put away in a previously defined place (labeled with a magnetic sticker) or if it doesn’t get hung. If the feature is enabled, the sound signal allows us to find the key and to remember to put the key away in the right place.
Page 5
In other cases, indicating the lock’s state takes place by making a move to the position shown in the figure below. A green LED means that the door has been locked, whereas a red LED means that the door is unlocked. At the same time, both diodes being on indicate an undefined state (only occurs after a complete configuration of the key cover).
Step 2: Configuration Use the button located in the upper part of the SureKey for changing the settings. Hold the button to enter the settings mode (the best choice for this task is a ballpoint pen or other object with a narrow tip - WARNING! The button has only to be pressed until it clicks - pressing too hard might damage the configuration button) for about 3 seconds –...
8. After hearing a short sound signal, continue locking until making one full turn. SureKey announces a calibration error with an adequate sound, after which you have to return to the lock’s initial position and press the button shortly to turn again.
Page 9
Closing notes The device utilizes a magnetic field to determine the lock’s state, which is why direct contact with magnets and magnetized elements should be avoided. In some instances, upon contact with a strong source of magnetic field, the device needs to be recalibrated. Low battery level will be announced with a modulated sound signal.
4. Restoration is possible only for devices contained in the database of sold devices with a proper serial number from Manufacturer or order ID. 5. Warranty defects and faults should be submitted to email: support@surekey.io. In the notification content, describe a problem, and leave your contact details. We answer notifications within five working days.
Disposal and recycling information When this product reaches its end of life, please dispose of it according to your local environmental laws and guidelines. The symbol below means that according to local laws and regulations your product should be disposed of separately from household waste.