Furrion FOS48TAPK-BL Operating And Installation Instruction page 8

Installation
Wiring the Camera
Electrical Power
•
The Furrion Wireless Observation Camera System can be connected to an
electrical power source via a 7 Way Connector.
•
Wiring to running lights: the camera will activate when the running lights are
switched on.
•
Wiring to reverse lights: the camera will activate when the vehicle engages
reverse gear.
•
When connecting wires, ensure
the circuit is isolated by disconnect-
-
ing the negative terminal on the
battery.
Connects to
Camera
Consult the vehicle's service manual for specific wiring color code.
7 WAY CONNECTION
When wiring this camera directly to a 12V battery or converter in your RV,
use an in-line switch on the power cable to power on or off your camera.
This will enable this camera to be used when parked without a tow vehicle
connected.
14
•
Ensure correct polarity when wiring
+
the cables. RED BLACK
•
Use 18AWG cables or higher
•
Wire connections & terminals
must be sealed & waterproof.
Connects to
12V/ 24V
Power Supply
Running,
Reverse or
Auxiliary
Lights
ON/OFF
IN-LINE SWITCH DC POWER SUPPLY
Positioning the Camera
•
Adjust the camera up or down then
check the view via the monitor.
•
When using the camera as a parking
camera, part of the vehicle, such as
the bumper, should be visible on the
monitor.
-
Reverse Camera
The camera can be tilted
up & down to obtain the
best viewing angle.
The camera can be wired to the
Rear Marker / Clearance light
power supply. When the lights
are turned on the camera will
be active.
Installation
Camera Positioning
Side View
15