Yamaha MS45DR Owner's Manual page 10

 Satellite speaker
[Rear]
Installing the Monitor Speakers
CAUTION
The MS45DR satellite speakers can be attached to straight vertical pipes of 1.5-inch (38.1-mm) diameter. These speakers cannot be
attached to curved pipes or any pipes of different diameter sizes.
1.
First insert the speaker mount of the satellite speaker
into the hole q of the pipe clamp, then tighten the wing
bolt.
Satellite speaker
Speaker mount
2.
As shown in Figure A, slowly insert one leg of your drum
rack through the hole w of the pipe clamp. When you
finish adjusting the position, tighten the wing bolt as
shown in Figure B.
CAUTION
Be sure to attach the satellite speakers to the leg of the
drum rack slowly and deliberately to avoid injury.
Be sure to tighten the wing bolts securely.
NOTE
[Figure A]
w
Drum rack leg
y [INPUT] jack
This jack is used to connect the satellite
y
speaker to the subwoofer.
Pipe clamp
q
Wing bolt
[Figure B]
Wing bolt
3.
See Figure C. Place the Subwoofer speaker on a flat
floor.
4.
Connect the satellite speakers, subwoofer speaker, and
the drum module via the included combination cable as
shown in Figure C.
WARNING
Use only the supplied power cord.
CAUTION
When setting up the product, make sure that the AC out-
let you are using is easily accessible. If some trouble or
malfunction occurs, immediately turn off the power
switch and disconnect the plug from the outlet.
3