Download Print this page

Items Needed - THUNDER TIGER Bandit 3.5 II Assembly Manual

Advertisement

INTRODUCTION
INTRODUCTION
Thank for purchasing Thunder Tiger Bandit 3.5
approved by Hydro World Champion Jorgen Andersson that means you will experience the racing thrill very soon. No
matter if you buy a Kit, Engine Combo or Ready to Run-Super Combo, read the manual thoroughly to familiar with this
boat as well as some assembling tips and safe cautions is strongly recommended.
Before you begin the assembly please check entire contents of the kit against the parts drawings to be sure that no
parts are missing or damaged. If you find that any parts are either missing or damaged, please contact your dealer
immediately for replacement. Note: Your dealer cannot accept kits form return if construction has begun.
Please contact Thunder Tiger authorized distributor for tech support and customer service if you encounter any
problem in assembly or running.
TABLE OF CONTENTS
Introduction..............................................................................................................................................2
Safety Precaution.....................................................................................................................................2
Other Items Required................................................................................................................................3
Items Need Check List...............................................................................................................................3
Parts Listing............................................................................................................................................4
Parts Drawings.........................................................................................................................................5
Assembly.............................................................................................................................................6-9
Radio Check.........................................................................................................................................10
Performance Tips & Racing...........................................................................................................................................11
Running Tips..........................................................................................................................................11
Maintenance ..........................................................................................................................................11
SAFETY PRECAUTIONS
Do not get anything close to the spinning propeller as it is dangerous and may cause serious injury.
Never run this boat in water where there is any swimmer, animal or obstacle. It might cause property damage and
serious injury if a collision occurs.
Refer to radio manual and always do the range, frequency checking to avoid any possibility of interference. Never
take the risk to run the boat without doing these checking procedures.
Model fuel is highly flammable. Always store it in cool, away from sparks or heat source.
Always exam the fuel lines and make sure there is no leak and fuel lines are in well condition.
Always start your engine in an open as it exhausts deadly carbon monoxide.
Do not touch the engine until it has cooled down. Special when pick up the boat from water.
Wear safety glasses is strongly recommended as spinning propeller may throw loose material such as sand or
gravel into your face.
Developed In Cooperation with
Hydro
World Champion
Jorgen Andersson
outboard tunnel hull! This performance F-1 racing boat is test
2
ITEMS REQUIRED FOR COMPLETION
Radio - A 2ch Radio with 2
standard servos is required.
Most 2ch radio is workable
a v a i l a b l e i n t h e m a r k e t .
However, we suggest a Pistol
Type radio gear is highly
recommended.
No.8217
Outboard Marine Engine-
Thunder Tiger #9567
2 1 M - O B 3 . 5 c c O u t b o a r d
Marine Engine is Strongly
Recommended.
No.9567
Adhesives- You will need two types of adhesives for the
assembly-epoxy and instant adhesives.
Tools-Model assembly can be much easier if the proper
tools are used.
Therefore we have included in our
checklist to above, a complete listing of all the tools we
used to assemble this boat. As you will notice, many
household tools can be utilized during construction.
OTHER ITEMS FOR COMPLETION
Carry Master-Thunder
Tiger offer a complete
organizer of field
equipment. All you
need is included.
No.1263-65

ITEMS NEEDED

Fuel
15~30% Nitromethane
Model Fuel.
Individual Item
Glow Starter-Thunder Tiger
2.4Ah high capacity Glow
Starter provides long time
power to the glow plug.
Each glow starter comes with
wallcharger.
No.2156~2161
12V DC Starter- Provides high
PRO-
torque starting power to start
your outboard engine.
No.2674
Sealed Battery- 7Ah 12V
Sealed Battery.
No.2624
Dry Cell- AA size 12 pcs Alkaline
dry cell are required.
4 way Wrench-Easy to unplug the
No.1102
glow plug.
Pump-An efficient hand crank fuel
pump.
No.1645
COMPREHENSIVE ITMES NEEDED
CHECK LIST
2ch Pistol Radio
5-min Epoxy
"Thin" Instant Adhesive
Hobby Knife and Blades
Epoxy Mixing Sticks
Masking Tape
Rubbing Alcohol
Paper Towels
Ruler
Misc. Household Tools
Hook & Loop Material
Balance Lead Weight (100~130g)
Drill bits: 1/8"[3mm], 9/32"[7mm]
3

Advertisement

loading