Champion CRH Series Instruction Manual page 5

H. After making sure that O-ring and wave spring inside top
of bowl are in place, reassemble bowl to head.
NOTE: Make certain O-ring is generously lubricated
NOTE: Wave spring ends should be pointed down to prevent
the wave spring from interfering with reassembly.
I. Reconnect drain tube to bulkhead fitting by pushing
tube into fitting until it locks in position.
J. Reinstall side and top panels.
K. Restore power and repressurize dryer. Resume
operation.
Element o-ring
Bowl o-ring
Tube
3.4
A.
B.
C.
D.
E.
F.
G.
H.
I.
Separator Element
J.
Wave Spring
K.
L.
Drain Mechanism
M. Restore power and repressurize dryer. Resume
Hose
Barb
Automatic condensate drain
• Check daily to be sure automatic drain is discharging.
• Replace drain mechanism yearly.
Shut-off compressed air supply to the dryer and depres-
surize. Turn off power to the dryer.
Remove top panel.
Remove two screws holding side panel then remove side
panel by sliding upwards.
Disconnect drain tube from bulkhead fitting in cabinet
base. To remove, press the plastic collar in, toward the
fitting, while pulling the tube out of the fitting.
Remove bowl - push bowl up, turn 1/8th turn to your
left, and pull bowl straight down.
Remove drain tube fitting from bottom of bowl.
Remove old drain mechanism by turning knurled fitting
to the right (clockwise) and remove.
Install new drain mechanism. If necessary, use a wire
or pencil to guide the new mechanism into place.
Reassemble drain tube fitting to bowl.
After making sure that large O-ring in filter head is in
place, reassemble bowl to head.
Reconnect drain tube to bulkhead fitting by pushing
tube into fitting until it locks in position.
Reinstall top and side panels.
operation.
5