Bionaire BCH3620 Owner's Manual page 5

MODES: To scroll through the various modes LO, HI, AL
and AH press the Mode Button until you reach your
desired setting.
OSCILLATION: To start oscillation, press the Osc. Button
once. To stop oscillation press the button again.
TEMPERATURE: To increase the temperature setting,
press the Temp Up button. To decrease the temperature
setting that you desire press the Temp Down button.
TIMER: To activate the timer from the remote control, press
the Temp Up and Temp Down buttons at the same time.
This will give you the ability to program the heater to turn
on or off in 1 hour increments up to 16 hours. For more
information see the Programmable Timer instructions
above.
CLEANING/MAINTENANCE
During Season Care:
1. Always unplug the heater before cleaning
2. Clean the unit with a soft cloth moistened with a mild
soap solution.
3. NEVER use abrasive or flammable solvents to clean
the unit.
4. After cleaning, be sure to completely dry the unit with
a cloth or towel.
After Season Care:
1. Store heater in a cool, dry location
2. The manufacturer recommends that you store the unit
in its original carton.
TIP: Over time, dust may accumulate on the front grills.
This can be removed by wiping the unit with a damp
cloth. Always unplug unit and allow to cool prior to
cleaning
6
TROUBLESHOOTING
If your heater fails to operate:
• UNPLUG THE UNIT
• Make sure the electrical outlet or circuit breaker is
working.
• Check for obstructions. If you find an obstruction turn
the heater OFF, and unplug the unit. Carefully remove
the obstruction and follow the reset instructions.
• The temperature may be set too low. Adjust the
thermostat until the heater restarts.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.
7