Wearing The Headset; Switching The Headset On Or Off; Taking The Headset Into Use For The First Time - Seecode VSH411 User Manual

Wearing the headset

You can put on the VSH411 Bluetooth
either ear.
To change the orientation of the earhook, detach the
earhook from the body part. To detach it, hold the
headset firmly and pull the earhook away from the post
around the earphone. Turn it over and replace on that
post.
To wear the headset, extend the earhook, then slide it
over the top of your ear. Put the earphone bumper
gently into your ear hole. Adjust your headset to your ear
carefully so that you feel comfortable.
Switching the headset on and off
SEECODE DOC VER 20041229.0.93.AIDfduj7839fduTHDOCTHOIO - 876YUIF
®
headset on
To switch on : press and hold the talk/power button for
2 or 3 seconds. The headset plays its booting melody
and the green indicator light starts blinking
Notice : If battery level is too low to power on when you
switched the headset on, it plays four tones in a row and
will not be switched on. You should charge the headset
and then, you can switch it on.
To switch off : Press and hold the talk/power button for
5 seconds. The headset plays and the indicator light
gone.

Taking the headset into use for the first time

®
Before you use Bluetooth devices, both devices you are
going to use should have datas such as Bluetooth
address, pass code. In other words, you must register
devices to each other. This process is called pairing.
Once you have paired two devices, you don't need to do
this again until you want to use the headset with another
device.
SEECODE DOC VER 20041229.0.93.AIDfduj7839fduTHDOCTHOIO - 876YUIF
®