Restore Defaults (Fix) - CDI CD42 Instruction Manual

CD42 Pipeline Pig Location & Tracking System
tone is bothersome to some. Therefore, if the operator wishes to do away with this beeping, he
simply goes to the More screen of setup and presses the button marked Beep (Figure 54).
Figure 54 Beep Icon
When the Beep button is pressed, the Beep option will toggle on and off. The current Beep setting
will be displayed in text at the bottom of the screen in the message area.
The display will read "xmitter pulses will beep" or "xmitter pulses will not beep". When the Beep
option is set to the desired setting, simply press the Back button to return to the Main screen. The
new setting is recorded as the default, so that the next time that the CD42-R unit is turned on, the
beeping option will remain the same.

Restore Defaults (Fix)

If the operator is having problems with the operation of the CD42-R unit, a possible solution is to
perform a software reset. This option can be found on the More screen of setup, and is labeled Fix (
Figure 55). This option restores all default settings for setup options, deletes all recorded pig
passages, and resets the system. This should only be performed if the CD42-R unit is
malfunctioning.
Figure 55 Fix Icon
To perform the system reset, press the Fix button. At this point the operator receives a warning
message (Figure 56), and is given the option to Abort the procedure if necessary.
Figure 56 Fix Final Warning Message
Page 37