Charging Instructions; Getting Started - Panda Hobby Tetra X1 Instruction Manual

CHARGING INSTRUCTIONS

This is a guide for the care and usage of the charger and battery that comes with the vehicle.
C636082-USB
Charger
C6360.81 -7.4V 500Mah Li - ion Battery
A.
CAUllON: The C636082 charger ls for use
Lu
with 2-cell 7.4V Li-ion batteries ONLYand
should not be used with any other batteries.
A.
CAUT I ON; Never leave the battery unattended
£.uwhile charging. Always disconnect the battery
and unplug the charger when finished charging.
A.
CAUTION: Never store the battery in your car
£.uin direct sunltght. Excessive heat rnay damage
the battery.
A.
CAUTION: Never charge
�damaged in anv wav. 1 -oose wires, punctured,
puffy or wet.
When using the C636082 charger, the C636081 battery should fully charge in 1 hour.
GmlNG STARTED
l[ I Remove the body clips and body.
�Install the battery.
TETRA ·
PAM1JA ilOBBI' ·
Retnove the battery from the vehicle before charging.
• Place the battery on a fire-(esistant surface away
from combustible materials.
• l<eep the battery and charger away from water and
other fluids. Never charge a wet battery.
1 , Connect the USB connector to a PC USS port or to a
USB AC wall adapter. The Red LED should be lit and
solid.
2. Connect the battery to the JST connector on the
charger. The Red LED should be lit and stay solid,
charging has commenced. The charger will
the battery i f it is
automatic.ally begin the charging process.When the
3. Red LED and the Green LED are both solid, the
battery is fully charged.
aa -.., O<I
= N[JR
o::J
I • •
<1lTurn on the transmitter.
I NSTRUCTION MANUAL
and the Green LED should Flash to indicate
Power to the vehicle is controlled by
connecting/disconnecting the battery.
@install the body and body clips.
•
©