Safety Precautions; Supplied Equipment And Required Equipment - Panda Hobby Tetra X1 Instruction Manual

1/18th scale crawler 4wd completely ready-to-run

Hide thumbs Also See for Tetra X1:

Instruction manual (46 pages)

Table Of Contents

Table of Contents

•

All instrucrIons and precaurlons outlined In this manual should be strictly followed to ensure safe operation

of your model. This model is not intended for use by children under

ofa responsible and knowledgeable adult.

We want you to safely enjoy your new model. Operate your model sensibly and with care, and it will be

exciting, safe, and fun for you and those a1ound you. I ailure to operate your model in a safe and responsible

manner may result in property damage and serious injury. The precautions outlined in this manual should

be strictly followed to help ensure safe operation. You alone must see thal the instructions are followed anc.l

the precautions are adhered to.

Important Points to Remember

•

Your model is not intended for use on public roads or congested aIeas where its operation can conflict

with or disrupt pedestrian or vehicular traff i c.

•

Never,

unde1

any

circumstances, operate the model

cause injury if

allowed

•

Because your model is controlled

beyond your control. Since radio interference can cause momentary losses of radio control, always allow a

safety margin in all directions around the model in 01der to prevent collisions.

• The motor and baltery can become hot during use. Be careful to avoid get ling burnt.

: Don'. t operate yoUI model at nighl, 01 anytime your line of sight to the model may be obstructed 01

1mpa1red

in any way.

•Most importantly, use good common sense at all limes.

ESC (Speed Control)

•

Disconnect

the

Battery: /\lways disconnect the battery from the model when not in use.

•

Transmitter on First: Switch on your transmitter first before switching on the speed

unaways and erratic perfo1 mance.

•

Don't Get Burnt: The motor can become exnemely hot during use,

cool. Make sure there is adequate airflow to the motor.

,Use the Factor y - Installed Connectors: Do nol change the battery connector. Improper wiring can cause

Are or damage to the tSC. Please note that modified speed controls can be subject to a rewiring fee when

returned for service.

•Insulate the Wires: Always insulaLe exposed or damaged wiring with heat shrink tubing to

citcuirs. More information please refer to your f-SC instruction manual.

SUPPLIED EQUIPMENT

7.4V

USB Charger

S00Mah

Li-ion Battery

Body Clips

Cross wrench

to collide with anyone.

radio,

subject to radio interference from many sources

SUPPLIED EQUIPMENT AND REQUIRED EQUIPMENT

2.4Ghz 3ch Full

Function Radio

Hex Wrench l .Smm

Jumper Plug