Transmitter Controls - Panda Hobby Tetra X1 Instruction Manual

TRANSMITTER CONTROLS

INSTALLING TRANSMITTER BATTERIES
This transmitter requires 4 AA batteries.
l .Remove the battery cover from the transmitter.
2.lnstall the batteries as shown.
3.1 nstall the battery cover .
.h\_ CAUT I ON: If using rechargeable batteries, charge only rechargeable batteries.
Lll
Charging non-rechargeable batteries may cause the batteries to burst, resulting
in injury to persons and/or damage to property .
.h\.
CAUTION: Risk of explosion if battery is replaced by an incorrection type.
Lll
Dispose of used batteries according to national regulations.
BINDING
YOUR TETRA Xl COMES BOUND AND READYTO OPERATE. N THE EVENT
THAT YOUR VEHICLE DOES NOT RESPOND TO THE TRANSMI T TER, FOLLOW
THE BINDING INSTRUCTIONS BELOW.
1 .Power OFF the ESC/Receiver and transmitter.
2.Connect a fully charged battery to the ESC/Receiver.
3.Press the Bind button and power on the transmitter, LED on transmitter
will flash.
4.Power on the receiver.
5.Receiver LED flash, when it goes solid, indicating the bind is successful.
M.W,A HOIIIII' · T ET R A · INSTRUCTION MANUAL
0