Sony BRAVIA KDL-23S2010 Operating Instructions Manual page 33

Option Description
Auto YC Both composite video and S Video can be connected to VIDEO 1 and VIDEO 2. Your TV by
default will automatically select to receive input signal from the S Video. Use this option when
you want to receive the input signal from the composite video.
1
2
Timer Settings Sleep Timer
Timer
Current Time
Power Saving
Select to reduce the power consumption by adjusting the backlight brightness. This also
enhances the black level. Select from Off, Low, High and Picture Off.
Light Sensor Select On to enable the automatic picture (screen) brightness control. The light sensor measures
the room brightness which allows the TV to automatically adjust the backlight brightness based
on the picture settings and the ambient room light conditions.
Quiet Power On Select to have the TV volume start at the minimum volume and gradually change to the set level
when you turn it on.
Press TV/VIDEO repeatedly until the desired video input appears.
After selecting the Auto YC option, to watch the pictures input from the S VIDEO input
jack:
Press V/v to highlight On, then press
To watch the pictures input from the VIDEO input jack:
Press V/v to highlight Off, then press
Set the time in minutes (Off, 15 min, 30 min, 45 min, 60 min, 90 min, or
120 min) that you want the TV to remain on before shutting off
automatically.
You can use the Timer to program the TV to turn and off, and to tune to a
specific channel at a scheduled time.
Timer feature will not be available until you set the Current Time.
1
Press V/v to highlight one of the following options, then press
Set: Select to set the timer by Day, Time, Duration, Channel and Volume
Setup.
Off: Select to turn off the timer. (Your previous settings are saved.)
2
If you selected Set in step 1, press V/v/B/b to set the day(s), hour,
minute, AM/PM, duration, channel number (VHF/UHF, CATV or
Digital), and volume.
When Digital is selected, the last digital channel you viewed will
automatically show when the TV is turned on.
3
Press MENU to exit Settings.
To return to the Timer Settings after programming the Timer or Current Time, press
.
B
Timer will be set to Off when:
- Auto Program for analog channels is executed.
- the AC power cord is disconnected and then reconnected to turn the TV on and
the Current Time is displayed as --:-- --.
Select to set the current time (day, hour, minute, and AM/PM).
1
Press
2
Press V/v/B/b to set the current time (day, hour, minute, and AM/PM).
3
Press MENU to exit Settings.
Be sure not to put anything around the sensor, as its function may be affected.
In low light the range of the backlight control is reduced when Light Sensor is set to On.
.
.
to select Current Time.
Using the Menus
.
(Continued)
33