Step 5: Connecting The Mains Lead; Step 6: Preparing The Remote - Sony RDR-GX210 Operating Instructions Manual

Step 5: Connecting the
Mains Lead
Plug the recorder and TV mains leads (power
cords) into the mains. After you connect the mains
lead, you must wait for a short while before
operating the recorder. You can operate the
recorder once the front panel display lights up and
the recorder enters standby mode.
If you connect additional equipment to this
recorder (page 23), be sure to connect the mains
lead after all connections are complete.
18
to mains
Step 6: Preparing the
Remote
You can control the recorder using the supplied
remote. Insert two R6 (size AA) batteries by
matching the 3 and # ends on the batteries to the
markings inside the battery compartment. When
using the remote, point it at the remote sensor
on the recorder.
Notes
• If the supplied remote interferes your other Sony DVD
recorder or player, change the command mode number
for this recorder (page 20).
• Use the batteries correctly to avoid possible leakage
and corrosion. Do not touch the liquid with bare hands
should leakage occur. Observe the following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an extended
period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid inside
the battery compartment, and insert new batteries.
• Do not expose the remote sensor (marked
front panel) to strong light, such as direct sunlight or
lighting apparatus. The recorder may not respond to the
remote.
on the