Advertisement
If press the key second time, enter into LOW-PASS Filter type setting, users are able to select 3 kinds
of Filter curve types ("-12dB", "-18dB", "-24dB") by rotating Encoder clockwise or anti-clockwise(show
as Fig.4c), At this time, if press Encoder, able to select the cut frequency(Rang:20Hz~20kHz) (show
as Fig.4d).
If press the key third time, enter into output PHASE setting, Users are able to select 0 or 180
by rotating Encoder clockwise or anti-clockwise(show as Fig.4e).
Press the key fourthly, entering into NOISE GATE setting, Users are able to select -30dB~-10dB by
rotating Encoder clockwise or anti-clockwise( show as Fig.4f).
10. OUT GAIN-- output gain setting. Firstly pressing the key, to enter into output gain setting(show as
Fig.5a). Users are able to select any one value from "-40dB~+6dB", the step is 1dB. If press the
key again, then output is quickly shut off to MUTE (show as Fig.5b), if press the key again, then return
to output normally adjustable status (show as Fig.5a).
CH:1 LOW-PASS
RESP/Q : -24dB
Fig.4c
CH:1 LOW-PASS
FREQ: 20.0kHz
Fig.4d
CH:1
PHASE
:0'
Fig.4e
CH:1
NOISE GATE
THRESHOLD
-30dB
Fig.4f
PR:1 M1:2X2Way+2Aux
PR:1
M1:2X2W+2S
CH:1 OUT PHASE
CH:1
GN : 0.0dB
Fig.5a
4
Advertisement
