Table of Contents
Advertisement
NOTES:
1. The above tubing confi gurations are guidelines to minimize tube stress.
2. Follow similar guidelines for discharge tubing and oil return tubing as needed.
3. If a run of over 20" is required, intermediate clamps may be necessary.
4. Do not hang weights on tubing (e.g. fi lter drier on suction tubing) except after clamps or close
to the header.
5. Tube runs of less than 8" are not recommended.
6. This dimension should be made as short as possible (e.g. 2" or less) but still insuring a proper
braze joint.
7. The above tubing recommendations are based on "no elbow joints". The use of continuous
tubing is preferred.
© 2014 Emerson Climate Technologies, Inc.
Printed in the U.S.A.
Application Engineering
B
U
L
Figure 3
Typical Suction Tubing
Figure 4
Motor Terminal (Fusite) Connections for
Single Phase and Three Phase Scrolls
L
E
T
11
I
N
AE4-1317 R10
Advertisement
Table of Contents
