Troubleshooting - QFX CR-30 User Manual

BATTERY INSTALLATION FOR POWER BACKUP - Requires 2
AAA Batteries (Not Included)
In case of a Power failure, the Battery Backup will keep the Clock & Alarm times accurate
until the main power has been restored.
During a power failure the LED display will remain OFF until power has been restored.
NOTE: Batteries are not required for normal use of this clock. The purpose of the Battery
Backup is to insure the correct Time & Alarm settings are stored in the Clock Memory in the
event of a power failure.
• Open the Battery Compartment by gently pushing the tab on the compartment door in
the direction indicated on the bottom of the clock.
• Insert 2 AAA batteries (not included) following the + / - polarity as indicated in the
compartment.
• Replace the door to the Battery Compartment and make sure it properly clicks in
place.
NOTE: Do not force the door as breakage may occur.

TROUBLESHOOTING

Symptom
Alarm did not sound
No sound
Time is Flashing
Possible Cause
- Alarm was not properly
turned ON.
- Alarm was not set to the
correct
Time (AM / PM)
- Clock not in correct
Function.
- Volume set at minimum
- Power Loss
Solution
- Check the LED Display
Lights
to insure the correct Alarm is
turned ON
- Check the Alarm Time reset
as necessary
- Press the FUNCTION
button
(1) to the desired Function
( FM, AM).
- Increase Volume.
- Reset the Time