Installation; Programming - Prince Castle 741-T2HW Series Operating Instructions Manual

INSTALLATION

1. After you have removed the timer from the carton,
inspect the unit for signs of damage. If there is
damage to the unit:
l
Notify carrier within 24 hours after delivery.
l
Save carton and packing materials for inspection reasons.
l
Contact your Prince Castle dealer or the Prince
Castle Customer Sales Department at 1-800-722-
7853, if purchased directly.
2. Verify that all parts have been received. Mounting
brackets and hardware provided
3. To mount the timer, place mounting brackets in desired
location. Scribe location of mounting holes, center punch,
and drill holes. Attach timer to mounting brackets
placing star washer between bracket and timer.
Note: Timers should be plugged into a dedicated outlet. No
other equipment should be operating on this line (i.e.
fryers, refrigerators, cash registers, etc.).
CAUTION: Solid state components in this timer are de-
signed to operate reliably in a temperatue range up to
o o
150 F (65.6 C. When installing this timer, it should be
confirmed that the ambient temperatures at the mount-
ing site do not exceed 150
DISPLAYS AND INDICATORS
TIME
Shows the time for the selected channel
Display
number.
H:M
Indicates the time value is in Hours and
Minutes.
M:S
Indicates that the time value is in
Minutes and Seconds.
LED
Located above each channel timer
Indicators
button, these lights change color
depending on the stage of the count-
down. Green = countdown cycle,
Red = auto reset cycle.
CONTROLS
SCAN/UP
In the program mode, it increases time
ARROW
values for each channel . In the Run
Mode, it is used in conjunction with logo
button to increase the volume.
Printed in USA 3/06 © 2006
o o
F (65.6 C).
SCAN/DOWN
In the program mode, it decreases time
ARROW
values for each channel . In the run
mode, it is used in conjunction with logo
button to decrease the volume.
PRINCE
Activates Program Mode and used to
CASTLE
adjust the alarm sound level.
Logo

PROGRAMMING

1. To program, press and hold the PRINCE CASTLE
logo for six seconds. The TIME display changes
from ---- to Prog, and a beep will sound.
See figure 1.
figure 1
Note: The timer leaves the factory preset at 60:00
minutes.
2. Select and press the timer channel to be pro-
grammed. The LED indicator for the selected
button will turn green and a beep will sound. The
current programmed time for that channel will be
displayed in the TIME display, and the time value
will indicate either H:M OR M:S. See figure 2.
figure 2
1
3. To change the program time for the selected
channel, use the SCAN/UP Arrow or the SCAN/
DOWN Arrow button.
2
P r o g
8:00
741-501revA