Trouble Shooting - Aclam Guitars Dr.Robert Vox UL730 User Manual & Safety Instructions

5 Tighten the two thumb screws with your hands or
with a screwdriver.
24
USING OTHER PEDALBOARDS:
Hook and Loop: Take the included super strong Velcro
pad and stick it on the base plate.
Again, make sure the base is clean of dirt and dust.
Pre-drilled pedalboard: Fix it with a bolt and a nut you
could find at any hardware store or instead of passing the
zip tie over the pedal you can take advantage of the Smart
Track enclosure and put the zip ties over the holes.
®
DIY woodboard: You can screw the pedal directly with
wood bolts through the enclosure side holes.
No board: If you use the pedals standalone make sure
you place the included anti-sliding rubber pad on the
baseplate.
Trouble
Shooting
SIGNAL PASSES THROUGH IN BYPASS BUT NOT
WHEN ENGAGED:
®
Make sure you´ve connected the input and output jacks
correctly.
PEDAL DOES NOT WORK WITH THE POWER SUPPLY:
Take a look at your power supply output voltage and
polarity. Make sure it's 9V DC negative tip with a minimum
output of 100 mA.
PEDAL WON'T ENGAGE WITH BOTH THE POWER
SUPPLY AND BATTERY:
Check there's a plug inserted into the Input Jack.
PEDAL SOUNDS DISTORTED AT REALLY LOW
SETTINGS:
- If you're running on batteries replace it with a new one or
check the voltage with a multimeter.
- The Dr. Robert is a really dynamic pedal the same way the
original amp is. Different types of guitars and pickups will
make it saturate in different regions of the knobs. That is a
totally correct response from the unit.
- Make sure there's not any pedal before the Dr. Robert
increasing too much the guitar's signal output, like
boosters, preamps compressors and other overdrive
pedals.
25