Advertisement
R
epair
[3] -2. Disassembling/ Assembling Gear Section and SJS (Clutch) Mechanism
DISASSEMBLING
1) Remove the Gear section by unscrewing four M5x14 Hex bolts. (Fig. 8)
2) Remove Ball bearing 6000LLB using Ball bearing extractor (Makita Part No.1R269). (Fig. 9)
3) Remove Retaining ring S-15 using Retaining ring S and R pliers (Makita Part No.1R291). Flat washer 15 can now be
removed. (Fig. 10)
Fig. 8
Hex bolt M5x14 (4pcs)
Gear section
4) See Fig. 11. Remove Spindle by pressing down from the Spiral bevel gear installation side using arbor press and Round
bar for arbor: Use a Round bar of 14mm or smaller.
Important: Be careful not to damage the Labyrinth ring 25 (The component of Spindle complete) in this step.
5) Remove the assembly of Spiral bevel gear 57 and Lock sleeve from Bearing box. (Fig. 12)
Fig. 11
Round bar for arbor
Spindle complete
6) While turning Lock sleeve clockwise with water pump pliers, Lock sleeve can be separated from Spiral bevel gear 57
by pulling the gear. (Fig. 13)
7) While turning Lock spring 24 clockwise with water pump pliers, Lock spring 24 can be separated from Spiral bevel
gear 57 by pulling the gear . (Fig. 14)
Important: Wrap Lock spring 24 with soft cloth or the like in order not to damage with the pliers.
Fig. 13
Lock sleeve
Spiral bevel gear 57
Fig. 9
Ball bearing 6000LLB
Labyrinth ring 25
(The component of Spindle complete)
Fig. 14
Water pump pliers
Lock spring 24
Fig. 10
No.1R269
Fig. 12
Spiral bevel gear 57
Soft cloth
Spiral bevel gear 57
P 4 / 6
No.1R291
Retaining ring S-15
Flat washer 15
Lock sleeve
Bearing box
Water pump pliers
Advertisement
