Makita Makstar BSS610 Technical Information page 7

W
iring diagram
This receptacle should be connected
to Terminal so as to face the lock
button for the Battery.
Battery's
lock button
Lead wire holder
Battery
Terminal
Lead wires (black and red) of
brush holders have to be expanded
near these lead holders to avoid
the lead wires' contacts with M6x90
flat head square neck bolt .
Micro switch
Terminal
Handle and Motor Housing
Lead wire holder
Main switch
Micro switch
See Fig.S.
Brush
Lead wire
holder
holder
Lead unit
The hole for
flat head square
neck bolt M6x90
Wiring of Micro Switch
The lead wires should not be pinched. Bending the terminals of Micro switch are
acceptable when the lead wires of micro switch are apt to be pinched by walls of
Motor housing and Handle cover. See below for the detail.
Wrong Wrong
These lead wires
are apt to be pinched.
Power supply
circuit
Wall of Handle cover
Censormatic chip
Put censormatic chip
into place at front handle
if it is used.
Power supply circuit
Pass the lead wires of power
supply circuit through this hole
to the blade case section.
Lead wire holder
Wrong
These lead wires are not pinched.
Inflected
terminals
P 7 / 7
Brush
holder