1. Manuals
  2. Brands
  3. Confidence Fitness Manuals
  4. Fitness Equipment
  5. NHCFV-2300
  6. Quick start manual

Confidence Fitness NHCFV-2300 Quick Start Manual

Hide thumbs

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NHCFV-2300 and is the answer not in the manual?

Questions and answers

Related Manuals for Confidence Fitness NHCFV-2300

Summary of Contents for Confidence Fitness NHCFV-2300

  • Page 2: General Information

    General Information • Read all instructions before using the Confidence Vibration Plate Power Plus. Only use the Confidence Vibration Plate Power Plus as described in the manual • It is the responsibility of the owner to ensure that all users are adequately informed of all precautions •...
  • Page 3 • Do not use the Confidence Vibration Plate Power Plus if you have any kind of injury • The Confidence Vibration Plate Power Plus is not be used immediately after eating • The Confidence Vibration Plate Power Plus is not to be used by pregnant women •...
  • Page 4 If you have any of the following conditions you must consult your doctor before using the Confidence Vibration Plate Power Plus • Heart Disease • Severe Diabetes • Fractures or previously fractured bones or joints • Epilepsy • Joint problems •...
  • Page 5 Resistance Bands Attach the resistance bands to the Vibration Plate main body by locating the metal arm underneath the machine. Move it out so that the arm is pointing out from underneath the disc. Loosen the carabiner lock (if required) on the end of the resistance band, clip it through the hole at the end of the metal bar, and then screw the lock on the carabiner clip into place Make sure the carabiner clip is fastened by screwing the lock in place, to...
  • Page 6 Signal Light ON/OFF Program PROGRAM Speed key SPEED Time Prog Speed Time TIME Program Display Time Display Speed Display ON/OFF SPEED KEY SPEED TIME TIME KEY PROGRAM KEY PROGRAM...
  • Page 7 1. Plug the Vibration trainer into the mains power socket, switch on the red power switch which located at the back of the machine. The LED will display Program Code for a second, then the LED will fully display for a second and then beep to indicate that the panel is in the standby mode.

Table of Contents