Setting The Digital Output Signal - Sony DVP-NS705V Operating Instructions Manual

STANDARD Normally select this position.
TV MODE
Makes the low sounds clear
even if you turn the volume
down.
WIDE Gives you the feeling of being
RANGE
at a live performance.
AUDIO FILTER (except Super Audio CD)
(DVP-NS905V only)
Selects the digital filter to reduce noise above
22.05 kHz (Sampling frequency (Fs) of the
audio source is 44.1 kHz), 24 kHz (Fs is 48
kHz), or 48 kHz (Fs is above 96 kHz).
SHARP
Provides a wide frequency
range and spatial feeling.
SLOW Provides smooth and warm
sound.
Note
There may be little effect by changing the digital
filter depending on discs or playback environment.
DOWNMIX (DVD VIDEO/DVD-RW only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital or DTS (DVP-NS905V
only) format. For details on the rear signal
components, see "Displaying the audio
information of the disc" (page 56).
This function affects the output from the
following jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack (for DVP-NS705V)
– LINE 1 (RGB)-TV jack (for DVP-
NS905V)
– DIGITAL OUT (OPTICAL or COAXIAL)
jack when "DOLBY DIGITAL" and "DTS"
(DVP-NS905V only) are set to "D-PCM"
(page 79).
DOLBY
Select this when the player is
SUR-
connected to an audio
ROUND
component that conforms to
Dolby Surround (Pro Logic).
NORMAL
Select this when the player is
connected to an audio
component that does not
conform to Dolby Surround (Pro
Logic).
DIGITAL OUT
Select this if audio signals are to be output via
the DIGITAL OUT (OPTICAL or
COAXIAL) jack.
ON
Normally select this position. When
you select "ON," see "Setting the
digital output signal" for further
settings.
OFF
The influence of the digital circuit
upon the analog circuit is minimal.
Note
Super Audio CD audio signals are not output from
a digital jack.

Setting the digital output signal

Switches the method of outputting audio
signals when you connect a component such
as an amplifier (receiver) or MD deck with a
digital input jack.
For connection details, see page 22.
Select "DOLBY DIGITAL," "MPEG,"
"DTS," and "48kHz/96kHz PCM" after
setting "DIGITAL OUT" to "ON."
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, damaging your ears or speakers.
DOLBY DIGITAL (DVD VIDEO/DVD-RW
only)
Selects the type of Dolby Digital signal.
D-PCM
Select this when the player is
connected to an audio
component without a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
"DOWNMIX" item in
"AUDIO SETUP" (page 79).
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
PCM
D-PCM
48kHz/16bit
,continued
79