Cisco Nexus 9396PX Hardware Installation Manual page 38

Nx-os-mode

Hide thumbs Also See for Nexus 9396PX:

Table of Contents

Powering Up the Switch

• Power source with the required amperage located within reach of the power cable being used

Step 1

Connect each power supply to a power source as follows:

• Connecting an AC power supply:

1 Using the recommended power cable for your country or region (see

connect the C13 plug on the power cable to the power receptacle on the power supply.

2 Rotate the cable retention clip on the power supply over the C13 plug to prevent accidental unplugging of the

cable.

3 Connect the other end of the power cable to the AC power source.

Verify that the

If the LED is off, check the AC power source circuit breaker to be sure that it is turned on.

• Connecting a DC power supply (see

If you require grid redundancy, be sure that each power supply is powered by a different power source.

Note

Step 2

If you are connecting only one power supply, be sure that there is a blank faceplate in the open power supply slot.

Cisco Nexus 9396PX NX-OS-Mode Switch Hardware Installation Guide

LED is on and green.

Wiring a 48 V DC Electrical Connector Block, on page

Installing the Chassis

Power Cord Specifications, on page

41)

47),

Table of Contents