Table of Contents
Advertisement
1
Safety notes
Please read this manual carefully and completely before you use the device for the first time. The
device may only be used by qualified personnel and repaired by PCE Instruments personnel.
Damage or injuries caused by non-observance of the manual are excluded from our liability and
not covered by our warranty.
The device must only be used as described in this instruction manual. If used otherwise,
•
this can cause dangerous situations for the user and damage to the meter.
The instrument may only be used if the environmental conditions (temperature, relative
•
humidity, ...) are within the ranges stated in the technical specifications. Do not expose
the device to extreme temperatures, direct sunlight, extreme humidity or moisture.
Do not use the meter during thunderstorms.
•
•
Do not expose the device to shocks or strong vibrations. Dropping it can damage the
electronic parts or the case.
•
The case should only be opened by qualified PCE Instruments personnel.
Never use the instrument when your hands are wet. Keep the meter dry.
•
You must not make any technical changes to the device.
•
•
The appliance should only be cleaned with a damp cloth. Do not use chemicals,
cleaning solvents or detergents.
The device must only be used with accessories from PCE Instruments or equivalent.
•
Before each use, inspect the case for visible damage. If any damage is visible on the
•
meter or its test leads, do not use the device.
•
Do not use the meter if it operates incorrectly. Protection may be compromised.
Do not operate meter while Low Battery warning is on. Replace batteries immediately.
•
Use only new batteries of the recommended size and type. Remove old or weak
•
batteries to avoid leakage and damage to the meter.
If the meter is not used for a longer period of time, remove the batteries.
•
•
Do not use the instrument in explosive atmospheres or near explosive vapours, dust or
gases.
The measurement range as stated in the specifications must not be exceeded under
•
any circumstances.
Ensure that the test leads are fully seated in the input jacks and keep your fingers away
•
from the metal probe tips when taking measurements.
•
Before changing functions using the selector switch, always disconnect the test leads
from the circuit under test.
Use only UL listed test leads with the proper safety category rating.
•
•
Comply with all applicable safety codes. Use approved personal protective equipment
when working near live electrical circuits-particularly when there is arc-flash hazard.
Use caution on live circuits. Voltages above 30 V AC RMS, 42 V AC peak, or 60 V DC
•
pose a shock hazard.
•
Verify functionality before using meter by measuring a known live voltage.
Do not apply voltage or current that exceeds the meter's maximum rated input limits.
•
Non-observance of the safety notes can cause damage to the device and injuries to
•
the user.
© PCE Instruments
1
Advertisement
Table of Contents
