Let's Get The Photo Frame Ready; Remote Control; Stand - Sony S-Frame 4-259-434-13 (1) Operating Instructions Manual

Let's get the photo frame ready

P Note
If the remote control stops
working:
Replace the battery (CR2025 lithium
battery) with a new one.
P WARNING
• Battery may explode if mistreated.
Do not recharge, disassemble or
dispose of in fire.
• When the lithium battery becomes
weak, the operating distance of the
remote control may shorten, or the
remote control may not function
properly. In this case, replace the
battery with a Sony CR2025
lithium battery. Use of another
battery may present a risk of fire or
explosion.
Replacing procedures:
CD-ROM (Handbook), "Preparing
the remote control"
zTips
x When the photo frame is
placed in the portrait
orientation
The display is automatically rotated
on the portrait orientation.
x Sony logo
When the photo frame is placed in
the portrait orientation or when you
turn off the power, the Sony logo
doesn't light up.
GB
10

Remote control

Pull out the protective sheet before use as shown in the
figure.
Using the remote control
Point the top end of the remote control towards the remote sensor on
the photo frame.

Stand

Turn the stand clockwise until the stand stops turning and
is firmly attached to the stand socket on the rear panel.
You can set the photo frame to portrait or landscape orientation by
rotating it without moving the stand.
Protective sheet