Advertisement
M1200 – Quick start-up manual – English (EU) – 01/03/2018 - ISSUE 2
When bleeding the machine, the trigger must be
pushed to allow water to flow out of the lance. Failure to
do so will cause the machine to display a fault message.
✓ Once button '1' or '2' of Error! Reference source not
found. is pressed the bleed screen represented in Figure
4 will appear.
Figure 4 - Bleed screen of the PLC
✓ Wait until the purge is completed. A new screen will
appear, represented in Figure 5.
5
1
2
4
Figure 5 - Start screen of the PLC
3
✓ Press 'START', the button turns green and the screen
represented on Figure 6 will appear.
Figure 6 - Running screen of the PLC
✓ The amber 'HEATER'
light will illuminate and the red
'FAULT' button should go out. This indicates that the
boiler has switched on and is heating the water
✓ The green 'READY' light will illuminate when the M1200
has reached operating temperature and the system is
ready for use (3 – 5 minutes).
5
Advertisement
