Replacement Parts; Troubleshooting Guide - Outbound 076-5453-2 Owner's Manual

B
PROBLEM
Condensation occurs when warm moist air inside tent comes in contact with cooler outside air. Avoid touching walls to reduce contact leakage. Venting doors and
1. CONDENSATION
windows will reduce condensation. Store wet clothing outside of tent. A battery powered fan may be helpful. Not applicable to screen houses.
Apply a generous amount of seam sealer on inside seams. Seam sealer may be purchased at any local sporting goods store.
2. SEAM LEAKAGE
To avoid mildew, store tent/screen house ONLY when thoroughly dry. However, if mildew occurs use a soft bristle brush or sponge with mild dishwashing soap or Fels
3. MILDEW
Naptha soap to clean. Let dry thoroughly and a tent approved water repellent compound may be applied.
4. REPAIRING A TEAR For small tears use a self-adhesive patch kit. We recommend a canvas or awning repair shop for larger tears.
5. FAULTY ZIPPER Zippers are self repairing. If the zipper separates, you can move the slider to the beginning of the zipper tape and rework the zipper.
Do not leave up in direct sunlight longer than necessary. If left in sunlight for prolonged periods of time, fabric will fade and weaken.
6. FADING FABRIC
A ground cloth under the floor helps prolong its life, provides additional insulation and moisture protection. The cloth should be smaller than the floor to prevent rain
7. FLOOR CONDENSATION
from running under the tent. Not applicable to screen houses.
Stakes should be installed at a 45 degree angle using a hammer or mallet. Stake loops should be kept taut without over stretching fabric or webbing. This could cause
8. USE OF STAKES
tears or leakage. To remove safely, use a hammer or stake puller. Do not remove by pulling on the fabric.
A
B
C

TROUBLESHOOTING GUIDE

SPECIFICATIONS:
KEY
NO.
DESCRIPTION
Fibreglass Pole - Main
A
B Fibreglass Pole - Side
C Fibreglass Pole - Fly
Replacement Fly
D
E Tent Stakes - Metal
SOLUTION
8 persons
Floor size: 14' x 13' (4.27 x 3.96m)
Centre height: 76" (1.93m)
Weight: 18.5 lbs (8.39kg)

REPLACEMENT PARTS

MODEL NO. CTC171413 (076-5453-2)
PART NO.
HFP11-545f
HFP9.5-474f
HFP11-480f
HTFCTC171413
HMS4-7
QTY.
REQ.
1
2
1
1
18
CTC 171413 10/16