Installation - Divus Touchzone Series User Manual

The original packaging has to be used for all transportations, including the one back to the distributor or manufacturer in case
of repair. Otherwise DIVUS can't give any guarantee for the product. Any damage occurring to the product if incorrectly packed
will be charged to the client. Furthermore in such a case DIVUS will charge an additional fee for packing.
For repair processes the "repair request" document has to be compiled and returned with the product to allow us to guarantee
an efficient service and a two week repair time.
For technical reasons only complete products can be returned for repair.
2.3

INSTALLATION

2.3.1 INSTALLING WALL MOUNT BOX
The wall mount box may be installed in a cut out in the wall, in a wooden structure thick at least 1.5 cm or in a drywall
construction. The cut out has to respect the sizes specified in the technical data and has to be at least 8 cm deep.
In the wall cut out, the box can be built in or it can be screwed on in a piece of furniture. It is important that the fore edge of
the wall mount kit is flat and horizontally to the surface of the wall or the piece of furniture.
The wall mount kit offers cable access on all four sides.
2.3.2 INSTALLING TZ
Switch off the system/plant supply voltage. Connect the power and controlling cables. After connecting the magnet to the
back of the mount box, the TZ is put into the wall mount box and is fixed with the screws included in the packing. Now you
can install your design frame with slight, even pressure.
Unauthorized changes or modifications to the TZ configuration may result in permanent damage to the system or its
functionality. Only authorized trained personnel are allowed to make any modifications.
If you need to remove the design frame, extract it from the mounting horizontally. One-sided traction or slanted installing
may damage the frame.
In order to be able to dissipate the heat produced by the equipment, it must be guaranteed that the temperature within the
mounting box does not exceed 45°C. Under normal conditions this is given with an ambient temperature of up to 30°C. If
these values are exceeded, additional cooling has to be provided.
The equipment must be installed vertically, i.e. the front plate must be in an angle of 90° to the base plate. Installation has
to comply to HD 60364-4-41 or other national prescriptions.
DIVUS TOUCHZONE .
18