Commissioning - Divus Touchzone Series User Manual

2

Commissioning

2.1 GROUNDING
The following must be heeded to ensure that all electrical interference is safely absorbed:
-
Connect the metallic wall mount kit with a central grounding point using the shortest possible distance.
-
Make sure that the connection between the unit and the grounding point has the lowest possible impedance.
-
All data cables connected to the unit must be shielded.
-
The shields must be grounded at both ends. A low-impedance connection must be established between the linked
units. High compensation currents over the cable shields caused by potential differences must be excluded.
-
Use a green-yellow cable with a minimum cross section of 2,5mm² for ground connection.
2.2 COMMISSIONING
The power supply of the TOUCHZONE is provided either through "Power over Ethernet (PoE)" - IEEE 802.3at - (TZ07, TZ10 and
TZ15) or through the DC input on DC in plug (TZ07, TZ10, TZ15 and TZ19). Using DC input, the used power supply needs to
provide safety extra-low voltage (SELV) and has to be compliant to EN60950-1 par.2.5 and EN61558-2-6 or equivalent. The
TZ07 and TZ10 versions must be powered through a supply providing max. 15 VA under normal operating conditions.
For all versions you must have the means for disconnection incorporated in the fixed wiring. Have the appliance connected to
the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening. If
using PoE+, ensure that your switch, injector or power adapter is fully PoE+ compliant.
Power consumption of the device is defined in the technical documents.
Pull out the power plug before opening the unit. Check all cable connections before commissioning the system. Make sure
that all voltages and signals meet the specifications.
Only TZ07, TZ10 and TZ15 support PoE+. TZ19 must be powered through DC in.
Though TZ07, TZ10 and TZ15 support hybrid power supply by both PoE+ and DC in at the same time, only one power input
should be used at a time.
DIVUS offers a warranty of 24 months after shipment (valid from the date of delivery) if not stated otherwise for the DIVUS
TOUCHZONE. The warranty is only valid if all transportation takes place with the original package of the product, including all
shock absorbing elements.
Every repair shipment has to be approved by the technical support. Contact us under support@divus.eu. On that occasion
you also get all necessary information, as well as the accompanying letter "repair request".
DIVUS TOUCHZONE .
17