iDevices IDEV0005 Installation Manual page 9

Thermostat on the home screen. Tap the 'Menu'
button in the upper left-hand corner. From
here, you can edit the details of your iDevices
Thermostat, organize it into a 'Room' and 'Zone',
set schedules and create 'Scenes'.
Warnings And Safety Information
Do not short across terminals on the gas valve or at
the heating or cooling system control board to test the
thermostat installation. This could damage the thermostat
and void the warranty.
Do not select COOL mode if the outside temperature is
below 50ºF (10ºC). This could damage the controlled
cooling system.
Testing Your System
1. Set your iDevices Thermostat to HEAT
®
mode. Adjust the temperature set point
above the ambient temperature in the room,
and verify that the heat turns on.
2. Set your iDevices Thermostat to COOL
®
mode (if outside temperature is above
50ºF). Adjust the temperature set point
below the ambient temperature in the room,
and verify that the cooling turns on.
3. If your system has dual fuel sources (heat
pump plus electric or fuel-fired emergency
heat), set your iDevices
to EMERGENCY HEAT mode. Adjust the
temperature set point above the ambient
®
temperature in the room, and verify that the
heat turns on.
4. Note: If you have a heat pump or air
conditioner, the iDevices
designed to prevent damage to your
compressor by waiting 5 minutes between
restarts of your air conditioner or heat pump.
If you are testing the operation of your air
conditioner or heat pump, wait at least 5
minutes after changing the temperature
setting for the system to turn on.
5. If all of the available system modes function
properly, the test is complete.
16
Thermostat
®
Thermostat is
®
17