SCRAM Systems SCRAM CAM Quick Reference Manual page 3

Table of Contents

Advertisement

2017 Alcohol Monitoring Systems, Inc. All rights reserved. Information in this document
©
is confi dential and proprietary to Alcohol Monitoring Systems, Inc. Such information is
subject to change without notice and does not represent any commitment or promise
on the part of Alcohol Monitoring Systems, Inc. Any software described in this document
is furnished under a license agreement. No part of this manual may be reproduced
or transmitted in any form or by any means, electronic or mechanical, including
photocopying and recording, for any purposes without the express written permission of
Alcohol Monitoring Systems, Inc.
Please read, understand, and follow all information contained in this manual prior to using
the SCRAM Continuous Alcohol Monitoring (CAM) Bracelet and Base Station. Retain this
manual for future reference.
Patents: www.scrampatents.com
Intended Use
The SCRAM CAM Bracelet, SCRAM Base Station, and SCRAM Wireless Base Station are
part of an alcohol monitoring system and transfers data to a computerized monitoring
network. This equipment is intended for use on individuals being monitored by a trained
supervising authority.
Health and Safety Notice
Improper installation or use of this SCRAM
Refer to Health and Safety Notice at www.
scramsafety.com or on SCRAM
and follow instructions to avoid injury.
Cleaning
Properly clean and disinfect SCRAM CAM Bracelets before installation using instructions
provided on the SCRAMNET Help page.
To avoid damaging equipment, use only cleaning and disinfecting products approved by
SCRAM Systems on the SCRAMNET Help page. Never use citrus or pine-based cleaning
products. To avoid contaminating alcohol sensors within SCRAM Systems products, never
use alcohol or alcohol-containing cleaning products.
Battery Warnings
CAM bracelet batteries are non-rechargeable. Do not attempt to charge CAM bracelet
batteries.
Dispose of batteries in accordance with all applicable local regulations.
Replace CAM bracelet batteries when recommended by SCRAMNET or by SCRAM Systems
Customer Service.
Always use 3V lithium CR2 batteries in SCRAM CAM Bracelet.
Base Station and Wireless Base Station
Caution – Base station contains Li-ion or Li-polymer battery. Do not heat, throw into fi re,
deform, short circuit, immerse in or wet with water.
Caution - Risk of Explosion if base station battery is replaced by an incorrect type.
Use only base station replacement batteries provided by SCRAM Systems.
Dispose of batteries in accordance with all applicable local regulations.
Replace base station batteries when recommended by SCRAMNET or by SCRAM Systems
Customer Service.
To recharge base station use only the provided SCRAM Base Station charger.
WARNING
device may cause injury.
NET
Bracelet
Help page
SCRAM CAM
Quick Reference Guide
i

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SCRAM CAM and is the answer not in the manual?

Table of Contents

Save PDF