Function At Loss Of Signal E1; Signals From Internal Feedback - AUMA Matic Series Calibration Instruction

AUMA Matic Positioner
Calibration Instruction

1) Function at loss of signal E1

Fail as is Actuator stops immediately after loss of E1 and remains in this position
Fail close Actuator runs to the closed position after loss of E1
Fail open Actuator runs to the open position after loss of E1

2) Signals from internal feedback

0/4-20ma From optional RWG electronic feedback
0-5 VDC From standard precision potentiometer (4.7 or 5KΩ)
3) Fail function not possible at loss of E2
ISSUE 02/02
All information in this document is subject to change without notice.
Page 11 of 11
AUMA Actuators, Inc. USA
SE-SI-35-0007