Print Magnet Assembly Removal; Latch Pusher Removal - IBM Selectric Maintenance Manual

FIGURE 32. Selector Bail Removal
FIGURE 33. Selector Bail Removal
PRINT MAGNET ASSEMBLY REMOVAL
1. Disconnect the cycle-clutch trip link (#1, Figure 34).
2. Remove the support leg in the lower left corner (#2,
Figure 34).
3. Remove the four mounting screws (#3, Figure 34).
4. Carefully remove the magnet assembly.
FIGURE 34. Print Magnet Assembly Removal
LATCH PUSHER REMOVAL
*
1. Remove the two screws (#1, Figure 35) that hold the con-
tact plate to the frame. Remove the contact assembl y,
holding it to the front with a rubber band.
2. Disconnect the pusher springs (#1, Figure 36).
3. Remove the C-clip on the end of the shaft (#2, Figure
36) and remove the shaft unt i I the desi red pusher is free.
4. The following adjustments should be checked after a
latch-pusher is replaced.
a. Latch to pusher clearance
b. Latch-pusher to armature clearance
*
Not present on all printers.
FIGURE 35. Latch Pusher Removal
3-9