Sony DSC-T3/T33 Operating Instructions Manual page 114

Others
Symptom
Your camera does not work.
The power is on, but the camera does
not work.
You cannot identify an indicator on
the screen.
The lens gets fogged.
The camera becomes warm when you
use it for the long time.
114
Cause/Solution
• You are not using an "InfoLITHIUM" battery pack. Use an "InfoLITHIUM" battery pack (page
130).
• The battery level is low. (The  indicator appears.) Charge the battery pack (page 14).
• Connect the AC Adaptor securely to the multi connector of your camera and to a wall outlet (wall
socket) (page 19).
• Properly install the camera to the Cyber-shot Station (page 12).
• The built-in microcomputer is not working properly. Disconnect, and then, after one minute,
reconnect all power sources and turn on the camera. If this does not work, press the RESET button
on the lower right side of the control button with a fine-tipped object, then turn the power on again.
(This will clear the date and time settings, etc.) (page 105)
• Check the indicator (pages 133 to 137).
• Moisture condensation has occurred. Turn off the camera and leave for about an hour at room
temperature for the moisture to evaporate before use (page 128).
• This is not a malfunction.