The safety and reliability of the device may be at risk
if, for example:
- visible damage is evident on the device,
- visible damage is evident on the connecting cable,
- the device has been subjected to excessive loads
for which it is not designed,
- the device has been improperly stored,
- the device has been damaged in transit,
- inscriptions or lettering on the device are illegible,
- malfunctions occur,
- permitted tolerances or threshold values
are exceeded.
4. Safety regulations
4.1 General safety regulations
Use of the explosion-proof Ex-DT assumes that the
operator complies with conventional safety regulations
and has reas the certificate in order to eliminate faulty
operation of the unit. The following additional safety
regulations must also be observed:
- In the ex-area, take measurements only on
widle circuits.
- The device must not be opened within the
ex-area.
- The batteries must only be changed outside the
ex-area.
- Additional or spare batteries must not be
carried in the ex-area.
- Only the batteries listed in the Owner's Manual
wmust be used, as these batteries are type-
wapproved.
- Only accessories approved by ecom
instruments GmbH may be used.
- If the cable insulation or test probe become
damaged, the device must be taken out of
woperation immediately.
9
9
Need help?
Do you have a question about the Ex-DT 12 and is the answer not in the manual?