Reprogramming A Single Homelink Button - Johnson Controls HomeLink Operating Instructions And Programming Manuallines

Rolling Code Synchronisation
Your vehicle must be within operating range of the gate or g Your vehicle must be within operating range of the gate or g
be switched on. Make sure you comply with the safety instru
rolling code.
1. Locate the training button (programming button) on th
unit. Exact location and colour of the button may vary
(refer to the operating instructions of the gate or garag
remote controls").
2. Press the training button (programming button) on the
unit (which will usually activate a "training" light).
Note: Following step 2, there are typically 30 second
3. Firmly press and release the programmed HomeLink
button a second time to complete the training process
may
require you to do this procedure a third time to comple
The gate or garage door opener should now recognise the H
HomeLink button is pressed.
The remaining two buttons may now be programmed if this
Please refer to Programming.

Reprogramming a Single HomeLink Button

If a HomeLink button has been programmed to activate a de
to operate a different device, proceed as follows. This proce
of the respective HomeLink button.
1. Press the appropriate HomeLink button
I, II, or III which you want to program
and keep holding it for about 20 seconds
until the diode starts flashing slowly (fig.6).
Do not release until step 4 has been
completed.
2. 2. When the diode begins to flash slowly (after When the diode begins to flash slowly (after
approximately 20 seconds), hold the remote
control of the device you wish to train approx.
5-30 cm away from the HomeLink transmitter
unit - keeping the diode in view.
5 Johnson Controls
garage door opener and the ignition should garage door opener and the ignition should
uctions even when synchronising the
e gate or garage door opener motor head
by gate or garage door opener brand
ge door opener "Training additional
e gate or garage door opener motor head
ds in which to initiate step 3.
button. Press and release the HomeLink
s. (Some gate or garage door openers
ete the training).
HomeLink signal and activate when the
has not previously been done.
evice, and you now wish to use this button
edure will erase the existing programming
Fig. 6