Johnson Controls HomeLink Operating Instructions And Programming Manuallines page 7

Technical Information for OEM Service
Diagnostics Di i
If, after carefully reading and following the above instruction
your original remote control, assistance is available via our t
Before you call, please make sure that you have the followin
reference. The Hotline operators will need this information to
Procedure for obtaining diagnostic information directly
(Note that these steps, carefully followed, will not erase you
1. To determine the Software Revision of your HomeLin
I or III, (but NOT both!) for about 100 seconds, at w
and turn completely off. Continue to press the butto
start flashing again. The number of flashes is equivale sta t as g aga
HomeLink system.
For example, seven flashes would mean Re
2. To determine the Region Code status of your HomeL
button II for about 100 seconds, until the diode exti
hold button II. A few seconds later, the diode will sta hold button II A few seconds later the diode will sta
of flashes will indicate the Region that your HomeLink
to operate in. For example:
One Flash
Two Flashes
Three Flashes =
Four Flashes
3. Additionally, the Hotline will request from you the follo
and the original transmitter you are trying to program:
A. Make and model of your vehicle, including y
of purchase;
B. Original remote control brand, model, age a
The Software Revision and Region Code status are especia
Please take a moment to gather the information outlined in t
7 Johnson Controls
e u be o as es s equ a e
= Rest of Eu
= France
U.K.
= Italy
s, you still cannot successfully train your HomeLink to
toll-free Customer Service Hotline 008000 466 35465.
ng HomeLink Diagnostic Information available for
o assist you with any difficulties you may have.
y from your HomeLink :
r programmed HomeLink channels).
nk press and continue to hold button
which point the diode will stop flashing
on. A few seconds later, the diode will
ent to the software version of your e t to t e so t a e e s o o you
evision 7.0.
ink, press and continue to hold
nguishes and remains off. Continue to
art flashing again. The number art flashing again The number
k system has been factory programmed
urope
owing information about your vehicle
:
year of manufacture and country
and operating frequency, if known.
ally important for solving training issues.
the above three steps before you call the Hotline.