Johnson Controls HomeLink Operating Instructions And Programming Manuallines page 3

Programming
When programming the HomeLink system the bes When programming the HomeLink system the bes
!
are inserted into the remote control for the garage
HomeLink can be programmed in just one minute, after whic
Garage doors and property gates can be opened at the touc
Please follow the safety instructions and apply the handbrak
engine!
1. Press and hold the two outside buttons I and
III (fig. 3) - releasing only when the diode begins to
flash after approximately 20 seconds.
Note: This procedure erases the factory-set
default codes and does not have to be followed
to program the other HomeLink
2. Hold the original remote control of the device you wish
from the HomeLink transmitter unit keeping the diode
The distance between the remote control and the Hom
system being programmed. You may require several a
each setting position for at least 15 seconds before try
3. Using both hands, simultaneously push the
remote control button and the desired
HomeLink button (fig 4) HomeLink button (fig. 4).
Do not release the buttons until step 4
has been completed.
4. The HomeLink diode will flash, first slowly
and then rapidly. When the diode flashes
rapidly, release both buttons. rapidly release both buttons
The rapid flashing light indicates successful
programming of the new frequency signal.
To program the remaining two buttons, follow steps 2 to 4.
3 Johnson Controls
st results are achieved if new batteries st results are achieved if new batteries
e door opener.
ch all functions can be used immediately.
ch of a button.
ke. Switch on the ignition. Do not start the
®
buttons.
h to train at a distance of 5-30 cm away
in view all the time.
meLink transmitter unit depends on the
attempts at different distances. Maintain
ying out another.
Fig. 3
Fig. 4