Table of Contents
Advertisement
Overview
Note
Be sure to power this unit off before proceeding to the
following operation.
1
Remove the two screws and gently pull the SDI
unit out.
Note
Be careful not to pull the SDI unit out too far.
Doing so may disconnect or damage the
connectors.
2
Open the cable holders of the SDI unit.
12
I I N
S D
Screw
1
2
Screw
3
Change the connections for both cables as shown
below.
4
Close the cable holders.
5
Repeat step 1 in reverse to return the SDI unit to
its original position.
6
Open the cover of the setting switches on the front
panel.
7
Set system setting switch 3 as shown below.
Before changed
(VBS mode)
After changed
(SDI mode)
Hide quick links:
Advertisement
Table of Contents
