Americaloc GL300 Start Manual

Before using our products or installing a device, carefully read our legal
terms which you can find at

To activate your account and device:

1. Go to www.americaloc.com, select United States and click the Activate Now button.
2. Fill in the required information. The IMEI code can be found below the bar code that is printed on
the back of your device. Your account will now be ready to use.
3. Go to www.americaloc.com
previous step.
4. Purchase one of our service plans by clicking on the Click to pay service button. A window will
open to provide you with payment instructions.
5. Your device should be active within 15 minutes of payment. This is the time the SIM card takes to
activate. If it takes longer and you do not want to wait,
ON after initial service
do not remove the SIM

Appearance:

LED behavior:

RED (POWER LED)
GREEN (GSM LED)
BLUE (GPS LED)
GL300 START GUIDE
http://us.americaloc.com/legal_info.html
and log in with the username and password established in the
payment. Your device already comes with a SIM card installed.
card.
.
please turn your device OFF and then

The POWER key is in the upper side of the device.

POWER ON: Press the power key for 5 seconds.
Check LEDs are ON before using.

POWER OFF: Press the power key for 5 seconds,
release the button and wait until the
LEDs power off. It may take up to a minute for the
device to power down.

CHARGING: Fully charge your device before using
it for the first time. A full charge takes about 2
hours.

Fast flash: Charging

Slow flash: Low battery

Dark: Normal behavior or Device OFF

Solid: Charging completed

Fast flash: Searching for network

Slow flash: Registered on network

Dark: Device OFF

Solid: GPS position calculated

Fast flash: Calculating GPS position

Slow flash: Wrong GPS data (no GPS
signal)

Dark: Off or device is in not moving
Please
|1