Table of Contents
Advertisement
10.2 Network planning
The suggested cable characteristics have to be as follows:
Type of cable
RS 485 cable
RS 232 cable
I/O wire
Power supply
(*)
Depends on application and on voltage and cable type. The last device installed
must have voltage enough to operate properly.
10.2.1 Connection to the Gateway GW-00
To each backplane connector of the Gateway GW-00 up two CM-IC can be connected.
CMX-ICto which are connected
the CMX boards
40[51]
No of wire
2
3
2 (for I/O point)
2
Table 10.4 - CMX-16/8 power supply data
Fig. 10.1
Data and design subject to change without notice. Supply subject to availability
© Copyright by CERBERUS AG, CH-8708 Männedorf, Switzerland 1995
Cross section
Unit
2
1.5
mm
2
0.5
mm
2
1
mm
2
1.5 (*)
mm
HARDWARE INSTALLATION
Gateway GW00
Subsystem Pad
connector
01.96
E1110A.DOC
Advertisement
Table of Contents
