The Cmx-Bp Connection Backplane; The Cmx-Sb Single Box - Siemens Cerberus Dati Technical Manual

9.2 The CMX-BP Connection backplane

The CMX-BP (CD91202) is an accessory that allows to connect the CMX-xx to the I/O wires, the communication lines
and the voltage supply. The CMX-BP is composed of a 64-pin DIN connector on one side and two rows of screw
connectors on the opposite side. Fig. 9.5 shows the connector layout and the dimensions.
The CMX-BP can be used by itself (it can be mounted on an existing panel by screws) or in the CMX-SB and in the
CMX-RM.

9.3 The CMX-SB Single Box

This accessory is a plastic box (see Fig. 9.6 and Fig. 9.7 for the dimensions) that can house one CMX board of any
model. The CMX-SB is composed of the box body, a serigraphed aluminium front panel and the box back. Moreover, to
properly mount the CMX you need the CMX-BP backplane.
First of all, you have to make a hole in the base for the cables and then to mount it on the wall. Then connect the
cables to the backplane connector. Remember that the screw part of the connectors is detachable. Insert the
connectors in their place and screw the box body to the box back, using the two internal screws supplied. Insert the
CMX board and mount the front panel.
36[51]
Fig. 9.5
Data and design subject to change without notice. Supply subject to availability
© Copyright by CERBERUS AG, CH-8708 Männedorf, Switzerland 1995
ACCESSORIES
01.96 E1110A.DOC