Changing The Lamp; Safety Regulations; Realize The Lamp Change; Changing The Gobos - GLP JUNIOR SCAN 2 Lnstruction Manual

JUNIOR
-eLp-
5
Changing the lamp
For a frictionless operation please read this chapter carefully and follow all instructions.
5.1
Safety regulations
.
Pull out the main plug!
.
Wait at least 20 minutes after the last operation to cool down the fixture.
.
Don't touch the bulb of the lamp with bare fingers (this can cause damages).
.
Before you put the JUNIOR SCAN 2 into operation close the casing,
othenryise
your retina can be
hurt!
5.2
Realize
the Lamp
Change
Please see also lllustration 1-1 on page
3.
1. Open the two Phillips screws on the bottom of the case.
2.
Pull out the lamp holder sheet including the lamp securely.
3.
Remove the old/broken lamp.
4.
Put in the new lamp securely in reverse order. Use only the originally lamp type.
Do not touch the new lamp with bare fingers.
5. Apply the lamp holder sheet back again into the shaft.
6.
Close the two Phillips screws afterwards.
7. Now
the
maximum light output can be
adjusted
with the three
adjustment
screws on the back side of the lamp holder sheet.
Attention: The glass bulb of the lamp can splinter. For that reason remove the
lamp with safety gloves or some cloth.
Pay
attention on
a
firm fit of the lamp
!!!
11
GLP
r
German Light Production