Philips Norelco 6000 Series Manual page 29

Cleaning the beard styler attachment
Clean the beard styler attachment after each
use.
1 Pull the comb off the beard styler
2 Rinse the cut hairs off the cutting unit with
3 Rinse the cut hairs off the comb.
4 Remove the cutting unit from the beard
5 Rinse cut hairs out of the beard styler
6 Carefully shake off excess water and leave
7 When the cutting unit is dry attach it to the
2
1
attachment.
Note: Grab the comb in the center to pull it
off the beard styler attachment . Do not pull
at the sides of the comb.
lukewarm water.
styler attachment. By pushing the cutting
unit from the beard styler attachment you
can remove any hairs that have
accumulated inside the beard styler. You
can also rinse the back of the cutting unit.
attachment.
the comb, cutting unit and beard styler
attachment to dry before next usage.
beard styler attachment.
29
English